PlasmaDyn© Plasma Cutter Replacement Parts Experts in Plasma Cutting Parts, Service & Repair for over 10 Years Includes: TIG Foot Pedal - 10K Pot with Adjustable Input on Front this pedal comes WITHOUT plugs This Foot Pedal is for TIG & MIG welders using a 2 Pin + 3 Pin Plug Most MOST Chinese Made machine (using 2 pin + 3 Pin plugs) Precisely Control your TIG Welder Current for the ultimate in welding ON/OFF + Current Control - BEST PRICE ANYWHERE!! Includes: 2k ohm - 10k ohm 2W potentiometer fits virtually all TIG welders using a voltage controlled current output circuit ~12 foot heavy duty neoprene jacketed cord comes with NO PLUGS The wiper wire is the current control wire and can be determined by checking the middle wire on the potentiometer inside the foot pedal. You must determine the 'wiper' input of your machine - this is the wire that controls output Note: - plugs are NOT INCLUDED - we sell several types below: Miller - 14 Pin Plug available here Large 7 Pin Plug (5/8") available here Small 7 Pin Plug (1/2") available here Small 2 Pin + 3 Pin Plug (1/2") available here Note: you must understand how to connect this part - we are not able to accept returns for fitment or compatibility. or - buy this foot pedal with both plugs pre-connected HERE YOU MUST VERIFY COMPATIBILITY BEFORE PURCHASE Fits MOST Chinese TIG/Plasma welders with 2 + 3 Pin Connectors This Foot Pedal will work - uses standard 10K potentiometer Please be sure YOUR machine is Foot Pedal Capable Schematic and Instructions Link See hook-up schematic and pin-out below Note: you MAY have to swap the wires inside the foot pedal to accommodate your machine - we can always offer help You MUST BE SURE This Pedal Fits and Works with your machine Sorry, there are no returns due to fitment or if your machine wont work with this pedal Sorry - we cannot tell you if it does or if you need a 10k pot - but if your machine has a 2 pin + 3 pin connection - it probably will work Note: you may have to swap wires inside pedal For Compatibility Questions - please call us at 314-329-8553 |
Find the on/off connection of your machine (Pedal Red-Black)
Find the 2 pins where you get voltage ~ 20-30V (Pedal - Blue Green)
The remaining wire is the wiper wire (Pedal - Grey)
If the control is backwards - reverse Pedal Blue & Green
NOTE: WIRE COLORS VARY ON EVERY FOOT PEDAL
EXAMPLE diagram ONLY - wire colors will vary on each foot pedal |