2"-14" Inch Silver Linear Actuator Stroke 225 Pound Max Lift Output 12V Volt DC
Store category
- Store Home
- Air Cleaner
- Air Compressor
- Air Intake & Fuel Delivery
- Alternator
- Bracket
- Brakes & Brake Parts
- Camshaft
- Computer, Chip, Cruise Control
- Connecting Rods
- Control Arms
- Crankshaft
- Cylinder Head
- Disc Brake Rotor
- Distributor
- EGR Cooler
- Electric Radiator Fan
- Engine Block
- Engine Oil Dipstick
- Exterior
- Filter
- Flexible Radiator Hose
- Flywheel Dust Cover
- Fuel Cell
- Fuel Filter
- Fuel Gas Hose Line
- Fuel Pump
- Gauges
- Header Bolts
- Header Gaskets
- Headers
- Headlight
- Hood Hinges
- Hood Scoop
- Hose End Fitting
- Interior
- Leveling Lift Kit
- Linear Actuator
- Master Cylinder
- Master Cylinders & Parts
- Oil Cooler
- Oil Pan
- Oil Tank
- Overflow Tank
- Pulleys
- Rack and Pinions
- Radiator
- Spark Plug Wire Looms
- Spindles
- Starter
- Steering Accessory
- Steering Arms
- Steering Column
- Steering Column Adapter
- Steering Gear Box
- Steering Pump
- Steering Wheel
- Steering Wheel & Column
- Suspension
- Tie Rod Ends
- Timing Chain
- Timing Cover
- Transmission & Drivetrain
- U Joint
- Valve Cover
- Valve Cover Breather
- Valve Cover Gaskets
- Water Neck
- Water Pump
- Light Bar & Bulb
- Fender Flares
- New Product
- KS Products
- Other Supplers
- Other
Sign Up Now !
You may also like
-
-
-
-
-
-
-
-
2"-14" Inch Silver Linear Actuator Stroke 225 Pound Max Lift Output 12V Volt DC
Product Description
Product Description
There Might Be Minor Difference Depending On Measure Methods .
DESCRIPTION
--12 Volt DC, 225 Pound Max Lift.
--Stroke : 2 inch/ 4 inch/ 6 inch/ 8 inch/ 10 inch/ 12 inch/ 14 inch
--Speed: 10mm/Second
--Wiring included, pre-installed.
--Built-in clutch prevents over-extending and over-compressing.
--Professional Installation is Highly Recommended (No Instruction and Wiring Diagram Included)
INSTALLATION ( WARNINGS )
1. The total load on the actuator (structure weight, structure friction, and possible actuator friction) must be less than or equal to the rated load of actuator.
2. The moving load must be centered above the actuator extension tube so that actuator lifting point is located at the center-of-mass of the structure.
Unless the structural design is properly braced, off-centered loads will cause additional friction that can (1) exceed the rated load of the actuator or (2) cause the actuator shaft to bend and permanently fail.
3. Do not exceed the 10% duty cycle of the actuator: If the actuator is used at full load for 2.5 minutes, then it must remain off for 7.5 minutes.
Exceeding the duty cycle will cause the actuator motor to overheat and permanently fail.
User Manual
Mount the actuator by securing the top and bottom mounting holes to two fixed positions.
The stroke length of the actuator (e.g. 12 inches) and the limitations of the particular application will determine the location of the fixed mounting positions.
IMPORTANT: Confirm that up/down movement of the actuator is smooth and within the actuators stroke length after installation.
Secure the top and bottom mounting holes of the linear actuator onto the two mounting fixtures using 5/16” diameter bolts.
Connet the red wire to the positive post and the black wire to the negative pst of a 12 volt DC power supply.
--Wiring included, pre-installed.
--Built-in clutch prevents over-extending and over-compressing.
--Professional Installation is Highly Recommended (No Instruction and Wiring Diagram Included)
How to install the actuator?
Tips:
1. Prepare to connect the two wires of the actuator to a 12 volt battery
2. Brown wire to the positive terminal and Blue wire to negative terminal will make the actuator extend. To make it retract, just reverse the terminal connections.
3. To simplify the last step, you can prepare a reverse polarity relay or switch (not included) for the actuator. When you want the actuator to extend and retract, just press the switch
4. Your actuator will hold its position when the power is off. It will automatically stop when reaches the end.
The actuator has pre-installed inner limit switch, it cannot be adjustable.
Payment & Checkout Shipping Return Policy Who We Are Contact Us Payment & Checkout Shipping Return Policy Who We Are Contact Us
- Payment
- Shipping
- Return Policy
- Who We Are
- Contact Us
- Condition: Neuf
- Model: Length
- Length: 2 inch
- Brand: TransMountRacing
- MPN: DMTRL14-2
- Voltage: 12V
- Stroke Length: 2 inch/ 4 inch/ 6 inch/ 8 inch/ 10 inch/ 12 inch/ 14 inch
PicClick Insights - 2"-14" Inch Silver Linear Actuator Stroke 225 Pound Max Lift Output 12V Volt DC PicClick Exclusif
- Popularité - 7 personnes suivent la vente, 0.0 de nouvelles personnes suivent la vente par jour, 617 days for sale on eBay. Super grande quantité suivi. 1 vendu, 0 disponible.
- Meilleur Prix -
- Vendeur - 73.086+ articles vendu. 1.6% évaluations négative. Grand vendeur avec la très bonne rétroaction positive et plus de 50 cotes.